Seeeduino V4.2 is an Arduino-compatible board, which is based on ATmega328P MCU, Arduino UNO bootloader, and with an ATmega16U2 as a UART-to-USB converter. The following boards are fully or almost fully compatible with both the Arduino hardware and software, including being able to accept "shield" daughterboards. Several Arduino-compatible products commercially released have avoided the "Arduino" name by using "-duino" name variants. ![]() The name "Freeduino" is not trademarked and is free to use for any purpose. Īs a result of the protected naming conventions of the Arduino, a group of Arduino users forked the Arduino Diecimila, releasing an equivalent board called Freeduino. The official policy document on the use of the Arduino name emphasizes that the project is open to incorporating work by others into the official product. This miniature version of the Arduino uses a surface-mounted processor.Īlthough the hardware and software designs are freely available under copyleft licenses, the developers have requested that the name "Arduino" be exclusive to the official product and not be used for derivative works without permission. Uses a surface-mounted ATmega1280 for additional I/O and memory. Improved: automatically switching between USB and external power, eliminating jumper Improved: Host is able to reset the Arduino, pin headers for reset and 3.3 V, low dropout voltage regulator allows lower voltage on external power source Programming is carried out via Bluetooth. Similar to the Arduino NG, this has a Bluetooth module rather than a serial interface. Improved: FT232BM has been replaced by FT232RL to require fewer external components, LED on pin 13 added The Arduino Extreme uses many more surface mount components than previous USB Arduino boards and comes with female pin headers. The following have been superseded by later and more capable versions from Arduino.Īrduino USB v2.0Changed: USB replaces RS-232 interface, Improved: Arduino can be powered from host See also list of Official Arduino Boards in wikidata Superseded This Arduino was co-designed by Adafruit.ĭesigned and manufactured by SparkFun Electronics. This minimalist design is for wearable applications.ĭesigned and manufactured by SparkFun Electronics for use in semi-permanent installations.Īnalog joystick, four buttons, several sensors, 2 TinkerKit inputs and 2 outputs, LCD connector This small USB-powered version of the Arduino uses a surface-mounted processor. Late versions of this board support Power over Ethernet (PoE). A serial interface is provided for programming, but no USB interface. Most shields that were designed for the Duemilanove, Diecimila, or Uno will fit, but a few shields will not fit because of interference with the extra pins.īased on the same WIZnet W5100 chip as the Arduino Ethernet Shield. Uses the ATmega16U2 (ATmega8U2 before Rev3) USB chip. This uses the same ATmega328 as late-model Duemilanove, but whereas the Duemilanove used an FTDI chip for USB, the Uno uses an ATmega16U2 (ATmega8U2 before rev3) programmed as a serial converter. ![]() ![]() The Leonardo uses the ATmega32U4 processor, which has a USB controller built-in, eliminating one chip as compared to previous Arduinos. ![]() Unlike most Arduino boards, it operates on 3.3 V and is not 5 V tolerant.Īrduino Yún is the combination of a classic Arduino Leonardo (based on the ATmega32U4 processor) with a Wi-Fi system on a chip (SoC) running Linino, a MIPS Linux based on OpenWrt. Features 2 channel 12-bit DAC, 84 MHz clock frequency, 32-bit architecture, 512 KB flash and 96 KB SRAM. The first Arduino board based on an ARM processor. Intel® Curie™ module two tiny cores, an x86 ( Quark SE) and an ARCĬontains six-axis accelerometer, gyroscope and Bluetoothīeta test started in Aug 1, 2014, 32-bit architecture Many versions of the official Arduino hardware have been commercially produced to date: NameĪTMEGA4809, NINA-W132 Wi-Fi module from u-blox, ECC608 crypto deviceĬontains six-axis accelerometer, gyroscope the NINA/esp32 module supports Wi-Fi and support Bluetooth as Beta feature ĪTSAMW25 (made of SAMD21 Cortex-M0+ 32 bit ARM MCU, Where different from the Arduino base feature set, compatibility, features, and licensing details are included. Released under the official Arduino name.This is a non-exhaustive list of Arduino boards and compatible systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |